#
#	$NetBSD: HADES.in,v 1.17 2022/12/22 11:05:55 nat Exp $
#
# Medusa-Hades
#
# This configuration file is for a generic Medusa-Hades
#

#include "GENERIC.in"

pseudo-device	view	4	# View (graphics mapping)
pseudo-device	mouse	1	# mouse

#
# The following sections describe various hardware options.
#

ncrscsi0	at mainbus0	# NCR5380 SCSI driver
scsibus0	at ncrscsi0	# SCSI bus
zs0		at mainbus0	# Serial support through 8530
nvr0		at mainbus0	# nvram driver
lp0		at mainbus0	# centronics printer
ser0		at mainbus0	# UART on first 68901 (ttyB0)
grfbus0		at mainbus0	# bitmapped display's
grfet0		at grfbus0	# et4000/et6000/et6100 consoles
ite0		at grfet0
grfet1		at grfbus0
ite1		at grfet1
grfet2		at grfbus0
ite2		at grfet2
pcib0		at mainbus0	# PCI-bus
pci0		at pcib0
# wsdisplay/keybd: if used, remove grfbus* grfet* and ite*
#vga0		at pci? dev ? function ? # a PCI VGA card
#wsdisplay*	at vga? console ?	# as a wscons console
#wskbd0		at kbd0 console ?	# Keyboard
avmebus0	at mainbus0	# VME bus
vme0		at avmebus0
le0		at vme0	irq 5	# Lance ethernet (Riebl/PAM).
le0		at vme0 irq 4	# Lance ethernet (BVME410).
et4k0		at vme0		# Crazy Dots II
isab0		at mainbus0	# ISA-bus
isa0		at isab0
wdc0		at mainbus0	# IDE-bus
atabus* 	at wdc? channel ?
wd*		at atabus? drive ?
# ATAPI bus support
atapibus*	at atabus?

# ATAPI devices
cd*	at atapibus? drive ?		# ATAPI CD-ROM drives

# SCSI devices
sd* 	at scsibus? target ? lun ?	# SCSI disk drives
st* 	at scsibus? target ? lun ?	# SCSI tape drives
cd* 	at scsibus? target ? lun ?	# SCSI CD-ROM drives
#if !defined(SMALL030_KERNEL)
ch* 	at scsibus? target ? lun ?	# SCSI autochangers
ss* 	at scsibus? target ? lun ?	# SCSI scanners
dse*	at scsibus? target ? lun ?	# SCSI ethernet (Dayna)
se* 	at scsibus? target ? lun ?	# SCSI ethernet
uk* 	at scsibus? target ? lun ?	# SCSI unknown
#endif /* SMALL030_KERNEL */

#if !defined(SMALL030_KERNEL)
# Networking...
ne0	at isa0 port 0x300 irq 5	# NE2000 ethernet

#endif /* SMALL030_KERNEL */